A New Alternative Electrochemical Process for a Pre-Deposited UPD-Mn Mediated the Growth of Cu(Mn) Film by Controlling the Time during the Cu-SLRR

Abstract

A layer-by-layer deposition is essential for fabricating the Cu interconnects in a nanoscale-sized microelectronics because the gap-filling capability limits the film deposition step coverage on trenches/vias. Conventional layer-by-layer electrochemical deposition of Cu typically works by using two electrolytes, i.e., a sacrificial Pb electrolyte and a Cu electrolyte. However, the use of a Pb electrolyte is known to cause environmental issues. This study presents an Mn monolayer, which mediated the electrochemical growth of Cu(Mn) film through a sequence of alternating an underpotential deposition (UPD) of Mn, replacing the conventionally used UPD-Pb, with a surface-limited redox replacement (SLRR) of Cu. The use of the sacrificial Mn monolayer uniquely provides redox replacement by Cu2+ owing to the standard reductive potential differences. Repeating the sequence of the UPD-Mn followed by the SLRR-Cu enables Cu(Mn) film growth in an atomic layer growth manner. Further, controlling the time of open circuit potential (OCP) during the Cu-SLRR yields a technique to control the content of the resultant Cu(Mn) film. A longer OCP time caused more replacement of the UPD-Mn by the Cu2+, thus resulting in a Cu(Mn) film with a higher Cu concentration. The proposed layer-by-layer growth method offers a wet, chemistry-based deposition capable of fabricating Cu interconnects without the use of the barrier layer and can be of interest in microelectronics.