Time-Accurate, 3-D Computation of Wire Sweep During Plastic Encapsulation of Electronic Components
Author:
Yang H.-Q.1, Bayyuk S.1, Mazumder S.1, Lowry S.1, Krishnan A.1, Przekwas A.1, Nguyen L.2
Affiliation:
1. CFD Research Corporation, Huntsville, AL 35805 2. National Semiconductor Corporation, Santa Clara, CA 95051
Abstract
A computational technique is developed for accurate prediction of wire sweep during encapsulation of electronic components by transfer molding. The technique advances the current state-of-the-art by modeling the effects of the two-phase flow involved, the effects of the polymerization of the melt, and the effects of the time-dependence of the fluid and heat flows and of the wire stresses and deformations. The computational techniques used for separately computing the fluid and heat flows, for separately computing the structural-dynamic stresses and deformations, and for establishing two-way coupling between the separately computed “flow” and “structural” solutions are described. Validations comparing the computational predictions with the corresponding analytical solutions for reference cases with straight wires immersed in flowing liquids are presented and discussed. The validation results show close agreement with theory, and demonstrate the need for using large-deformation theory for computing wire deformations and stresses. Demonstrative results for the unsteady flowfield and wire sweep in a TO-220 package are also presented and discussed.
Publisher
ASME International
Subject
Mechanical Engineering,Mechanics of Materials,Safety, Risk, Reliability and Quality
Reference13 articles.
1. Nguyen, L. T.
, 1988, “Wire Bond Behavior During Molding Operations of Electronic Packages,” Polym. Eng. Sci., 28, pp. 926–943. 2. Nguyen, L. T., Danker, A., Santhiran, N., and Shervin, C. R., 1992, “Flow Modeling of Wire Sweep During Molding of Integrated Circuits,” ASME EEP-Vol. 2, PED-Vol. 60, pp. 27–38. 3. Tay, A. O., Yeo, K. S., Wu, J. H., and Lin, T. B., 1995, “Wirebond Deformation During Molding of IC Packages,” ASME J. Electron. Packag., 117, pp. 14–19. 4. Tay, A. O., Yeo, K. S., and Wu, J. H., 1995b, “The Effect of Wirebond Geometry and Die Setting on Wire Sweep,” IEEE Trans. Compon., Packag. Manuf. Technol., Part B, 18, No. 1, pp. 201–209. 5. Wu, J. H., Tay, A. O., Yeo, K. S., and Lin, T. B., 1996, “Three-Dimensional Modeling of Wire Sweep Incorporating Resin Cure,” Electronic Components and Technology Conference, pp. 1047–1055.
Cited by
11 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献
|
|