Affiliation:
1. Systems Engineering Laboratory, Sumitomo Heavy Industries, Ltd., 2-4-15 Yato-Cho, Tanashi-City, Tokyo 188, Japan
Abstract
A newly developed precise positioning system incorporating a surface-motor (SFM) drive unit is presented and its advantageous features, operation principles, electromagnetic drive force design, and some experimental results are described. The stage of our “SFM positioning system” is levitated on a base plate by three air bearing pads; being driven by three brushless-type linear DC motors in three degrees of freedom. The guidance and positioning of the stage’s planar motion are achieved via the simultaneous operation of three identical proportional-integral-derivative (PID) servo-control systems, each having a laser-interferometer position feedback loop. The electromagnetically produced drive forces are analyzed by employing magnetic permeability theory, with good correspondence being obtained between calculated and experimental results. Additionally discussed is the closed-loop dynamic behavior, including the motion caused by three axis-interference. Evaluations of experimental tests indicate that a positioning resolution of 10–20 nm and yaw angle accuracy less than ±0.08 µrad are successfully achieved for an x-y travel range of 10 mm.
Subject
Computer Science Applications,Mechanical Engineering,Instrumentation,Information Systems,Control and Systems Engineering
Reference14 articles.
1. Buckley
J.
, GalburtD., and KaratzasC., 1989, “Step-and-scan lithography using reduction optics,” Journal of Vacuum Science & Technology, Vol. B7, pp. 1607–1612.
2. Ebihara
D.
, WatadaM., and HigashinoH., 1991, “Basic Structure of Four Phase PM-type Stepping Surface Motor and the Driving Method,” T. IEE Japan, Vol. 111-D, No. 8, pp. 655–660.
3. Futami
S.
, FurutaniA., and YoshidaS., 1990, “Nanometer positioning and its micro-dynamics,” Nanotechnology, Vol. 1, pp. 31–37.
4. Kanai, A., 1986, “Ultra-precise position control using a force-controlled hydraulic actuator,” Proceedings 1986 Autumn Conference of JSPE, pp. 479–480.
5. Kano, Y., 1989, “Analysis and design of linear DC motor,” 1989 National Convention Record IEE Japan, pp. 169–173.
Cited by
12 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献