Automated Part Centering With Impulse Actuation

Abstract

Centering a part on a spindle for precision machining is a tedious, time-consuming task. Currently, a skilled operator must measure the run-out of a part using a displacement gauge, then tap the part into place using a plastic or rubber hammer. This paper describes a method to automatically center a part on a vacuum chuck with initial run-out as large as 2.5 mm. The method involves measuring the magnitude and direction of the radial run-out and then actuating the part until the part and spindle centerlines are within 5 μm of each other. The run-out can be measured with either a touch probe mounted to a machine axis or an electronic gauge. The part is tapped into place with a linear actuator driven by a voice coil motor. This paper includes an analysis of run-out measurement uncertainty as well as the design, performance modeling, and testing of the alignment actuator. This actuator was employed for part realignment and successfully positioned a hemispherical part with an initial run-out of 1–2.5 mm to within 5 μm of the spindle centerline. This capability shows that the run-out of a part manually placed on flat vacuum chuck can be automatically corrected.