Dynamic Analysis of the Ultrasonic Machining Process-Reference-Cited by-同舟云学术

Dynamic Analysis of the Ultrasonic Machining Process

Published:1996-08-01 Issue:3 Volume:118 Page:376-381
ISSN:1087-1357
Container-title:Journal of Manufacturing Science and Engineering
language:en
Short-container-title:

Author:

Wang Z. Y.¹,Rajurkar K. P.¹

Affiliation:

1. Nontraditional Manufacturing Research Center, Department of Industrial and Management Systems Engineering, University of Nebraska, Lincoln, NE 68588-0518

Abstract

This paper presents a dynamic analysis of the ultrasonic machining process based on impact mechanics. Equations representing the dynamic contact force and stresses caused by the impinging of abrasive grits on the work, are obtained by solving the three-dimensional equations of motion. The factors affecting the material removal rate have been studied. It is found that the theoretical estimates obtained from the dynamic model are in good agreement with the experimental results.

Publisher

ASME International

Subject

Industrial and Manufacturing Engineering,Computer Science Applications,Mechanical Engineering,Control and Systems Engineering

Link

http://asmedigitalcollection.asme.org/manufacturingscience/article-pdf/118/3/376/5558124/376_1.pdf

Reference17 articles.

1. Darlow, M. S., 1989, “Balancing of High-speed Machinery,” Springer-Verlag.

2. Dikushin, V. I., and Barke, V. N., 1958, “Ultrasonic Erosion and its Dependence on the Vibrational Characteristics of the Tool,” Stanki i Instr., No. 5, 10. pp. 1058–1066.

3. Goetze D. , 1956, “Effect of Vibration Amplitude, Frequency and Composition of the Abrasive Slurry on the Rate of Ultrasonic Machining in Ketos Tool Steel,” Journal of the Acoustics Society of America, Vol. 28, pp. 1053–1059.

4. Goetze D. , 1957, “Effect of Pressure Between Tool, Tip and Workpiece on the Rate of Ultrasonic machining in Ketos Tool Steel,” Journal fo the Acoustic Society of America, Vol. 29, pp. 426–430.

5. Kainth G. S. , NandyA., and SinghK., 1979, “On the Mechanics of Material Removal in Ultrasonic Machining,” Int. J. Mach. Tool Des. Res., Vol. 19, pp. 33–41.

Cited by 30 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Material removal modes and processing mechanism in microultrasonic machining of ball ceramic tool;Ceramics International;2024-08

2. Investigations into velocity decay, initial tool-workpiece gap, and material removal behaviour in ultrasonic micromachining;Journal of Manufacturing Processes;2024-08

3. Introduction;Vibration Assisted Machining;2023

4. Effect of system compliance on weld power in ultrasonic additive manufacturing;Rapid Prototyping Journal;2021-08-18

5. Slicing Ceramics on Material Removed by a Single Abrasive Particle;Materials;2020-09-28