Affiliation:
1. Solar Turbines Inc., San Diego, CA 92123
Abstract
Net radial loading arising from asymmetric pressure fields in the volutes of centrifugal pumps during off-design operation is well known and has been studied extensively. In order to achieve a marked improvement in overall efficiency in centrifugal gas compressors, vaneless volute diffusers are matched to specific impellers to yield improved performance over a wide application envelope. As observed in centrifugal pumps, nonuniform pressure distributions that develop during operation above and below the design flow create static radial loads on the rotor. In order to characterize these radial forces, a novel experimental measurement and post-processing techniquesis employed that yields both the magnitude and direction of the load by measuring the shaft centerline locus in the tilt-pad bearings. The method is applicable to any turbomachinery operating on fluid film radial bearings equipped with proximity probes. The forces are found to be a maximum near surge and increase with higher pressures and speeds. The results are nondimensionalized, allowing the radial loading for different operating conditions to be predicted.
Subject
Mechanical Engineering,Energy Engineering and Power Technology,Aerospace Engineering,Fuel Technology,Nuclear Energy and Engineering
Reference9 articles.
1. Agostinelli
A.
, NoblesD., and MockridgeC. R., 1960, “An Experimental Investigation of Radial Thrust in Centrifugal Pumps,” ASME JOURNAL OF ENGINEERING FOR POWER, Vol. 82, pp. 120–126.
2. Binder, R. C., and Knapp, R. T., 1936, “Experimental Determination of the Flow Characteristics in the Volutes of Centrifugal Pumps,” Transactions of the ASME, Paper No. HYD-58-4, pp. 649–661.
3. Branagan, L. A., and Barrett, L. L. E., 1993, “A Manual for Use With the Tilting-Pad Bearing Program THPAD,” Version 2.23b, ROMAC Report No. 284, University of Virginia.
4. Flathers
M. B.
, Bache´G. E., and RainsbergerR., 1996, “An Experimental and Computational Investigation of Flow in a Radial Inlet of an Industrial Pipeline Centrifugal Compressor,” ASME Journal of Turbomachinery, Vol. 118, pp. 371–384.
5. Flathers
M. B.
, and Bache´G. E., 1998, “Aerodynamically Induced Radial Forces in a Centrifugal Gas Compressor: Part 2—Computational Investigation,” ASME JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER, Vol. 120, No. 2, pp. 000–000.
Cited by
4 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献