An Analytical Model of Cutting Dynamics. Part 2: Verification

Abstract

The dynamic force model developed in the preceding paper [1] is further examined. The analysis shows a successful prediction of the forms of stability boundary over a wide range of cutting speed. It reveals that the cutting force acting on tool rake face controls the high-speed stability, while the ploughing force acting on tool nose region dominates the low-speed stability. A series of cutting tests were carried out to examine the validity of the model. The result shows a fairly good agreement between the theoretical prediction of stability limit and the experimental determination of critical width of cut when the cutting conditions are properly chosen to avoid the presence of built-up-edge on tool tip.