Affiliation:
1. The Ohio State University Gas Turbine Laboratory, Columbus, OH 43235
Abstract
This paper describes work done in preparation for the measurement of stage efficiency in a short-duration shock-tunnel facility. Efficiency measurements in this facility require knowledge of the flow with path pressure and temperature, rotating system moment of inertia, and mass flow. This paper describes in detail and improved temperature compensation technique for the pressure transducers (Kulite) to reduce thermal drift problems, and measurements of the rotating system moment of inertia. The temperature compensation has shown that the conversion to pressure is accurate to within 0.689 kPa (0.1 psi) over the 40°C test range. The measurement of the moment of inertia is shown to be accurate to within 0.7 percent of the average value.
Reference9 articles.
1. Dunn M. G. , and HauseA., 1982, “Measurement of Heat Flux and Pressure in a Turbine Stage,” ASME Journal of Engineering for Power, Vol. 104, pp. 215–223.
2. Dunn M. G. , RaeW. J., and HoltJ. L., 1984, “Measurement and Analysis of Heat Flux Data in a Turbine Stage: Part I—Description of Experimental Apparatus and Data Analysis, and Part II—Discussion of Results and Comparison With Predictions,” ASME Journal of Engineering for Gas Turbines and Power, Vol. 106, pp. 229–240.
3. Dunn M. G. , GeorgeW. K., RaeW. J., WoodwardS. H., MollerJ. C., and SeymourP. J., 1986, “Heat-Flux Measurements for the Rotor of a Full-Stage Turbine: Part II—Description of Analysis Technique and Typical Time-Resolved Measurements,” ASME JOURNAL OF TURBOMACHINERY, Vol. 108, pp. 98–107.
4. Dunn M. G. , BenetteW., DelaneyR., and RaoK., 1992, “Investigation of Unsteady Flow Through a Transonic Turbine Stage: Part II—Data/Prediction Comparision for Time-Averaged and Phase-Resolved Pressure Data,” ASME JOURNAL OF TURBOMACHINERY, Vol. 114, pp. 91–99.
5. Dunn, M. G., and Haldeman, C. H., 1994, “Phase-Resolved Surface Pressure and Heat-Transfer Measurements on the Blade of a Two-Stage Turbine,” Unsteady Flows in Aeropropulsion, ASME AD-Vol. 40, Ng, W., Fant, D., and Povinelli, L., eds.
Cited by
6 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献