Affiliation:
1. Institute of Tribology, Department of Mechanical Engineering, The University of Leeds, Leeds, LS2 9JT, U.K.
Abstract
This paper presents experimental results of motored engine tests on the wear and profile development of a twin-land oil-control ring. It is shown that the roughness height of the plateau honed liner decreases during running-in, indicating that the deeper grooves remain unaffected. The piston lands are much smoother, and do not show a significant overall change in surface roughness. The profile development results are compared with computer predictions in order to verify the theoretical modeling. It is indicated that the worn land profiles remain tapered, with an inclination resembling the twist angle of the ring. However, there remains a difference in the experimental and the numerically predicted land inclinations. This is probably due to the piston tilt, which was not included in the theoretical model.
Subject
Surfaces, Coatings and Films,Surfaces and Interfaces,Mechanical Engineering,Mechanics of Materials
Reference17 articles.
1. Barber
G. C.
, and LudemaK., 1987, “The Break-in Stage of Cylinder-Ring Wear: A Correlation between Fired Engines and a Laboratory Simulator,” Wear, Vol. 118, pp. 57–75.
2. Edwards, S. P., 1992, “The Contribution of Piston Ring Packs and Cylinder Bore Distortion to Engine Friction,” Ph.D. thesis, The University of Leeds, UK.
3. Furuhama, S., and Hiruma, M., 1975, “The Relation between Piston Ring Scuffing and the Formation of Surface Profile,” Piston Ring Scuffing, Proc. IMechE Conf., paper C67/75, pp. 35–43.
4. Greenwood, J. A., 1992, “Problems with Surface Roughness,” Fundamentals of Friction: Macroscopic and Microscopic Processes, Proc. NATO Adv. Study Inst. on Fundamentals of Friction, NATO ASI Series E: Applied Sciences, Vol. 220, pp. 57–76.
5. Greenwood
J. A.
, and TrippJ. H., 1971, “The Contact of Two Nominally Flat Rough Surfaces,” Proc. IMechE, Vol. 185, pp. 625–633.
Cited by
6 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献