Effects of axial length and integrated design on the aggressive intermediate turbine duct

Abstract

With the increasing demand of high bypass ratio and thrust-to-weight ratio in civil aero-engine, the intermediate turbine duct between the high pressure and low pressure turbines of a modern gas turbine tends to shorter axial length, larger outlet-to-inlet area ratio and high pressure-to-low pressure radial offset. This paper experimentally and numerically investigated the three-dimensional flow characteristics of traditional (ITD1) and aggressive intermediate turbine duct (ITD2) at low Reynolds number. The baseline case of ITD1 is representative of a traditional intermediate turbine duct of aero-engine design with non-dimensional length of L/dR = 2.79 and middle angle of 20.12°. The detailed flow fields inside ITD1 and flow visualization were measured. Results showed the migration of boundary layer and a pair of counter-rotating vortexes were formed due to the radial migration of low momentum fluid. With the decreasing axial length of intermediate turbine duct, the radial and streamwise reverse pressure gradient in aggressive intermediate turbine duct (ITD2) were increased resulting in severe three-dimensional separation of boundary layer near casing surface and higher total pressure loss. The secondary flow and separation of boundary layer near the endwall were deeply analyzed to figure out the main source of high total pressure loss in the aggressive intermediate turbine duct (ITD2). Based on that, employing wide-chord guide vane to substitute “strut + guide vane”, this paper designed the super-aggressive intermediate turbine duct and realized the suppression of the three-dimensional separation and secondary flow.