DENDRITIC GROWTH OF THE BINARY SUCCINONITRILE-CAMPHOR SYSTEM-Reference-Cited by-同舟云学术

DENDRITIC GROWTH OF THE BINARY SUCCINONITRILE-CAMPHOR SYSTEM

Published:2007-12 Issue:06 Volume:14 Page:1169-1179
ISSN:0218-625X
Container-title:Surface Review and Letters
language:en
Short-container-title:Surf. Rev. Lett.

Author:

ÇADIRLI E.¹,KAYA H.²

Affiliation:

1. Niğde University, Faculty of Arts and Sciences, Department of Physics, 51200, Niğde-Turkey, Turkey

2. Erciyes University, Education Faculty, Department of Science Education, 38039, Kayseri-Turkey, Turkey

Abstract

Succinonitrile (SCN)–2 wt% Camphor (CAMP) alloy was unidirectionally solidified with a constant temperature gradient (G = 3.01 K/mm ) at different growth rates (V = 6.5–113 μ m/s ) and with a constant growth rate (V = 6.5 μ m/s ) at different temperature gradients (G = 1.93 - 3.01 K/mm ). Microstructural parameters (primary dendrite arm spacings, λ1, secondary dendrite arm spacings, λ2, dendrite tip radius, R, and mushy zone depth, d) were measured as a function of growth rate and temperature gradient. The experimental results have been compared with theoretical models and previous experimental works. The stability constant (σ) for this alloy system was calculated and compared with similar experimental results.

Publisher

World Scientific Pub Co Pte Lt

Subject

Materials Chemistry,Surfaces, Coatings and Films,Surfaces and Interfaces,Condensed Matter Physics

Link

https://www.worldscientific.com/doi/pdf/10.1142/S0218625X07010767

Reference62 articles.

1. Dendritic Growth Velocities in Microgravity

2. J. D. Verheoven, The Fundamentals of Physical Metallurgy (John Wiley & Sons, Canada, 1975) p. 3.

3. Dendritic growth

4. Primary spacing selection in directionally solidified alloys

Cited by 6 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. The Effect of Growth Rate on the Microstructure and Mechanical Properties of 7020 Alloys;Journal of Materials Engineering and Performance;2021-10-25

2. Effect of convection on directional solidification in transparent succinonitrile–2.2wt.%(d)camphor alloy;Acta Materialia;2021-09

3. Microstructural, mechanical, electrical, and thermal properties of the Bi-Sn-Ag ternary eutectic alloy;Journal of Wuhan University of Technology-Mater. Sci. Ed.;2017-02

4. Influence of growth rate on microstructure, microhardness, and electrical resistivity of directionally solidified Al-7 wt% Ni hypo-eutectic alloy;Metals and Materials International;2013-01

5. INFLUENCE OF THE SOLIDIFICATION PARAMETERS ON DENDRITIC MICROSTRUCTURES IN UNSTEADY-STATE DIRECTIONALLY SOLIDIFIED OF LEAD–ANTIMONY ALLOY;Surface Review and Letters;2010-10