Analysis and Troubleshooting of the Hydraulic System about Bicycle Assembly Line-Reference-Cited by-同舟云学术

Analysis and Troubleshooting of the Hydraulic System about Bicycle Assembly Line

Published:2014-08 Issue: Volume:1006-1007 Page:139-141
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Yang Hong¹,Yu Xiao Guang¹,Xu Ze Ning¹,Xu Ming²

Affiliation:

1. Liaoning University of Science and Technology

2. Angang Group

Abstract

This paper analyzes hydraulic system of the bicycle assemply line,Aiming at the problem of the hydraulic system pressure not up to design standard when there is only a hydraulic pupm in the oil supperly system. Put forward to replaced two throttle valves by two check valves. The results show validity of the method.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.1006-1007.139.pdf

Reference8 articles.

1. ISO 6358-1989，Pneumatic Fluid Power-Components Using Compressible Fluids Determination of Flow-rate Characteristics[s].

2. M.H. Raibert, M.A. Chepponis H. Brown. Experiments in Balance With. a 3D. One-Legged Hopping Machine[J]. 75-92. Interrational Journal of Robotics Research; 1984, (3).

3. Cuangping He, Zhiyong Geng. Exponentially Stabilizing an One-Legged Hopping Robot with Non-SLIP Model in Flight Phase[J]. Mechatronics, 2009, 19(3); 364-374.

4. Semini C, Tsagarakis N G, Guglielmino E. Design of Hyq-A Hydraulieally and Electrieally Actuated Quadruped Robot[J]. Journal of Systems and Control Engineering, zon, 225(6): 831-849.

5. Coharrizi A Y, Sepehri N. A Warelet-based Approach to Internal Seal Damage Diagnosis in Hydranlic Actuators[J]. IEEE Transactions on Industrial Electronics. 2010, 57(5): 1755-1763.