Affiliation:
1. Henan Institute of Science and Technology
2. Beijing Institute of Technology
Abstract
In order to reveal the change rule of vibration acceleration during micro-end-milling straight groove, the single-factor and orthogonal experiments are employed to confirm the influence of milling parameters on vibration acceleration. On this basis, the relation equation between milling parameters and vibration accelerations is built. The result show that, the vibration acceleration along the width of groove is bigger than that of feed direction and it will increase rapidly with the improve of cutting speed; the predicted result of vibration acceleration is in good accordance with test result, therefore the relation equation can be used to predict vibration acceleration.
Publisher
Trans Tech Publications, Ltd.
Reference7 articles.
1. C. Friedrich, P. Coane, J. Goettert, Direct fabrication of deep x-ray lithography masks by micromechanical milling, Pre. Eng., 22 (1998) 164-173.
2. K. Sawada, S. Odaka, T. Kawai, Manufacture of diffraction grating on tiny parts by means of ultraprecision milling. Microsystem Tech., 5 (1999): 157-160.
3. I. Tansel, O. Rodriguez and M. Trujillo, Micro-end-milling. Inter. J. of Mach. T. & Manu., 38 (1998) 1419-1466.
4. K. Lee, S. Ahn, D. Dornfeld, et al., The effect of run-out on design for manufacturing in micro-machining process. Proc. of the ASME, New York, Nov. 11-16, (2001) 11-17.
5. Klaus Weinert , Tobias Surmann, Dirk Enk et al., The effect of runout on the milling tool vibration and surface quality. Pro. Eng. Res. Deve., 1 (2007) 265-270.