Affiliation:
1. Technical University in Košice
Abstract
This paper presents the conclusions of the cutting tool wear during the drilling of steel DIN 1.4301. Based on the cutting tests, cutting speeds of 40 to 100 m/min, feed rate of 0.05 to 0.5 mm and screw drill carbide monolite. The results of the article are conclusions for working theory and practice for drilling of steel DIN 1.4301.
Publisher
Trans Tech Publications, Ltd.
Reference11 articles.
1. M. Džupon-M. Gajdoš-J. Jurko-M. Ferdinandy-D. Jakubeczyová, Plastic Deformation Around Holes Drilled in Austenitic Steel 1. 4301. Chemické listy, Vol. 105, (S), pp.606-608, ISSN 0009-2770, (2011).
2. J. Jurko-M. Džupon-A. Panda-M. Gajdoš-I. Pandová, Deformation of Material Under the Machined Surface in the Manufacture of Drilling Holes in Austenitic Stainless Steel. Chemické listy, Vol. 105, (S), pp.600-602, ISSN 0009-2770, (2011).
3. J. Jurko, The cutting tool wear of the cutting tool part of the cast iron GTW 35-04 during drilling, Applied Mechanics and Materials, ISSN 1660-9336, Volume 470, 2014, Pages 589-592.
4. J. Jurko-A. Panda, Study of the tool life and the tool wear mechanisms in the production of holes in stainless steel. Applied Mechanics and Materials, ISSN 1660-9336, Volume 459, 2013, Pages 424-427.
5. J. Jurko, Study changes in tool wear of stainless steels ELC X01Cr18Ni10Ti when drilling. Advanced Materials Research, ISSN 1022-6680, Volume 785-786, 2013, Pages 1005-1008.