Affiliation:
1. Komsomolsk-on-Amur state University
Abstract
The paper describes a method which has been developed for obtaining the limiting drawing ratio of titanium and aluminum alloys, and determines the moment of failure of the work-piece. This method is based not only on the use of Forming Limit Diagram (FLD) in predicting the failure of the blank, but also the using method of variable parameters of elasticity in determining the stress-strain state in deep drawing process.
Publisher
Trans Tech Publications, Ltd.
Subject
Condensed Matter Physics,General Materials Science,Atomic and Molecular Physics, and Optics
Reference19 articles.
1. V.P. Romanovsky, Handbook of cold stamping: fifth ed,. M., Mechanical engineering, 1977 p.423.
2. Dorel Banabic. Sheet Metal Forming Processes. Constitutive Modelling and Numerical Simulation. London-New York: Springer Heidelberg Dordrecht, 2010, p.301.
3. G.S. Ma, M. Wan, X.D. Wu, Theoretical prediction of FLDs for Al-Li alloy at elevated temperature based on M-K model, J. Chinese Journal of Nonferrous Metals. 18 (2008) 980-984.
4. M. Yang, X.H. Dong, The Forming Limit Prediction Using a Rate-Dependent Crystal Plasticity Model, J. Journal of ShangHai JiaoTong University. 42 (2008) 720-723.
5. P.M. Du, L.H. Lang, B.S. Liu, Theoretical prediction and parameter influence of FLDs based on M-K model, J. Journal of Plasticity Engineering. 18 (2011) 84-89.
Cited by
2 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献