Abstract
In this paper, the nanomachining experiments on the SPR3001 photoresistor thin films were processing by contact mode atomic force microscopy (AFM). After the experiment, it can be found, in the nanomachining, the greater the indented distance along the Z-axis depth, carved out of the groove depth and groove width of nanoline is greater. The influences of cutting directions on line width and cutting depth during nanomachining were quite a few and the cutting situation was stable by lateral nanomachining. This article also successfully processed the regular hexagonal nanopattern, also proves the nanomachining ability of the AFM probe is good at nanoscale patterned on photoresistor thin films.
Publisher
Trans Tech Publications, Ltd.
Reference10 articles.
1. J. C. Huang, Y. J. Weng, S.Y. Yang, Y. C. Weng, and J. Y. Wang, Fabricating Nanostructure by Atomic Force Microscopy, Jpn. J. Appl. Phys. 48 (2009) 095001-1-095001-5.
2. J. C. Huang, Y. -J. Weng and J. W. Lee, Evaluation of the Nanofabrication and Corrosion on Copper by In-situ ECAFM, Journal of Chinese Society of Mechanical Engineers 32 (2011) 61-66.
3. J. C. Huang, Fabricating nanostructures through a combination of nano-oxidation and wet etching on the different surface conditions of silicon wafer, Scanning 34 (2012) 264-270.
4. J. C. Huang, J. W. Lee, C. L. Li, Nano-scratching and nano-machining in different environments on Cr2N/Cu multilayer thin films", Thin Solid Films 519 (2011) 4992-4996.
5. J. C. Huang, C. L. Li, J. W. Lee, The study of nanoscratch and nanomachining on hard multilayer thin films using atomic force microscope, Scanning 34 (2012) 51-59.