Affiliation:
1. Gheorghe Asachi Technical University of Iaşi
2. Gheorghe Asachi Tehnical University of Iasi
Abstract
The analysis of the drilling process addressed in this paper aims highlighting the factors able to exert influence on parameters of technological interest corresponding to such a process. There were applied the method of systemic analysis, Ishikawa diagram, SWOT analysis. The significance of the drilling tool active zone geometry within the drilling process and, in the tests for evaluation of the machinability by drilling was emphasized. With this aim in view, preliminary tests of using a specialized equipment for sharpening the small diameter drills were initiated.
Publisher
Trans Tech Publications, Ltd.
Reference9 articles.
1. S. Panait, Optimization systems of manufacturing, available at http: /www. cm. tuiasi. ro/docs/CURS_OSF_1. doc, accessed at 10. 07. (2014).
2. ** Plasma erosion, available athttp: /www. upm. ro/biblioteca/Grama/tehnologii-electrofizice-si%20mecanice-cu-energie-concentrata/cap. 1/1. 6. eroziunea-cu-plasma. doc, accessed at 10. 07. (2014).
3. M. Klaic, T. Staroveski, T. Udiljak, Tool wear classification using decision trees in stone drilling applications: a preliminary study, 24th DAAAM International Symposium on Intelligent Manufacturing and Automation, 69 (2013) 1326 – 1335.
4. S. Usui, J. Wadell, T. Marusich, Finite element modeling of carbon fiber composite orthogonal cutting and drilling, 6th CIRP International Conference on High Performance Cutting, HPC, 14 (2014) 211-216.
5. A. Tașkesen, K. Kütükde, Experimental investigation and multi-objective analysis on drilling of boron carbide reinforced metal matrix composites using grey relational analysis, Measurement, 47 (2013) 321–330.