Mechanical and Tibological Properties of SLM AlSi10Mg Alloy Subjected to ECAP-Reference-Cited by-同舟云学术

Mechanical and Tibological Properties of SLM AlSi10Mg Alloy Subjected to ECAP

Published:2021-11-02 Issue: Volume:326 Page:33-50
ISSN:1662-9779
Container-title:Solid State Phenomena
language:
Short-container-title:SSP

Author:

Snopiński Przemysław¹,Woźniak Anna¹,Król Mariusz¹^ORCID

Affiliation:

1. Silesian University of Technology

Abstract

In this study, selectively laser melted AlSi10Mg alloy was subjected to ECAP processing for the first time. Mechanical properties of the ECAP processed samples were compared based on hardness measurement, compression and wear tests. The results showed exceptional synergy of high yield strength ~382 MPa and strain to failure of ~48% of the SLM ECAP processed sample. This sample also offered approximately ~71% higher wear resistance, than an unprocessed one. The proposed novel route expands the opportunities of both technologies to produce materials with exceptional properties.

Publisher

Trans Tech Publications, Ltd.

Subject

Condensed Matter Physics,General Materials Science,Atomic and Molecular Physics, and Optics

Link

https://www.scientific.net/SSP.326.33.pdf

Reference63 articles.

1. D. Mayer, T. Bein, H. Buff, B. Götz, O. Schwarzhaupt, D. Spancken, Enhanced lightweight design by composites – Results of the EU project ENLIGHT, J. Reinf. Plast. Compos. (2018). https://doi.org/10.1177/0731684418762321.

2. J.C. González Palencia, T. Sakamaki, M. Araki, S. Shiga, Impact of powertrain electrification, vehicle size reduction and lightweight materials substitution on energy use, CO2 emissions and cost of a passenger light-duty vehicle fleet, Energy. (2015). https://doi.org/10.1016/j.energy.2015.10.017.

3. W.J. Joost, Reducing vehicle weight and improving U.S. energy efficiency using integrated computational materials engineering, JOM. (2012). https://doi.org/10.1007/s11837-012-0424-z.

4. G.B. Schaffer, S.H. Huo, J. Drennan, G.J. Auchterlonie, The effect of trace elements on the sintering of an Al-Zn-Mg-Cu alloy, Acta Mater. (2001). https://doi.org/10.1016/S1359-6454(01)00177-X.

5. P. Snopińśki, T. Tański, K. Matus, S. Rusz, Microstructure, grain refinement and hardness of Al–3%Mg aluminium alloy processed by ECAP with helical die, Arch. Civ. Mech. Eng. (2019). https://doi.org/10.1016/j.acme.2018.11.003.