Precision Grinding of SUS304 Using Metal Bonded CBN Wheel-Reference-Cited by-同舟云学术

Precision Grinding of SUS304 Using Metal Bonded CBN Wheel

Published:2007-09 Issue: Volume:24-25 Page:261-264
ISSN:1662-8985
Container-title:Advanced Materials Research
language:
Short-container-title:AMR

Author:

Hasuda Y.¹,Suzuki Y.¹,Tadokoro Y.²,Kinebuchi S.¹,Ohashi T.³,Furusawa T.⁴

Affiliation:

1. Utsunomiya Technical High School

2. University of Tsukuba

3. Industrial Technology Center of Tochigi Prefecture

4. Teikyo University

Abstract

The fundamental experiment of the grinding of the stainless steel using the metal bonded CBN wheel which was excellent in wear resistance was conducted. The most appropriate grinding conditions were obtained by clarifying wear process of grinding wheel and finished ground surface quality. When grinding was carried out up to stock removal 7000mm3/mm, radial wear of grinding wheel %R is 3μm and surface roughness Rz was 0.5μm or less. The grinding ratio Gr becomes about 3000, and long life grinding with little change of surface roughness was possible.

Publisher

Trans Tech Publications, Ltd.

Subject

General Engineering

Link

https://www.scientific.net/AMR.24-25.261.pdf

Reference7 articles.

1. H. Tanaka, N. Kumagaya: Journal of the Japan Society for precision Engineering, 58, 4, 601-603 (1992).

2. T. Matsuo, Y. Ohbuti, Y. Fukui & H. Shibata ：Proc. of S.M.E., The Third Int. Grinding Conf, Oct. 4-6, (1989) 1.

3. H. Notoya, S. Yoneya, Y. Takatsuji: Journal of the Japan Institute of Metals, 52, 2, 217-222 (1988).

4. Y. Hasuda & K. Kishi：Proc. of International Conference on Precision Surface Finishing and Burr Technology，110-115, (1994)130.

5. T. Matsuo: Journal of the Japan Society for precision Engineering, 58, 4, 571-612 (1992).

Cited by 3 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Grinding temperature and wheel wear of porous metal-bonded cubic boron nitride superabrasive wheels in high-efficiency deep grinding;Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture;2015-12-03

2. Influence of alumina bubble particles on microstructure and mechanical strength in porous Cu–Sn–Ti metals;Materials & Design (1980-2015);2015-01

3. Fabrication and performance of porous metal-bonded CBN grinding wheels using alumina bubble particles as pore-forming agents;The International Journal of Advanced Manufacturing Technology;2012-10-16