Temperature and Treatment Time Influence High Hydrostatic Pressure Inactivation of Feline Calicivirus, a Norovirus Surrogate†

Abstract

Interest in high hydrostatic pressure processing as a nonthermal pasteurization process for foods continues to increase. Feline calicivirus (FCV), a propagable virus that is genetically related to the nonpropagable human noroviruses, was used for detailed evaluation of the high pressure processing parameters necessary for virus inactivation. Pressure inactivation curves of FCV strain KCD in Dulbecco's modified Eagle medium with 10% fetal bovine serum were obtained at 200 and 250 MPa as a function of time at room temperature. Pressure inactivation curves at 200 and 250 MPa also were determined as a function of temperature ranging from −10 to 50°C at treatment times of 4 and 2 min, respectively. Tailing was observed for inactivation as a function of treatment time, indicating that the linear model was not adequate for describing these curves. The two nonlinear models, the log logistic and Weibull functions, consistently produced better fit to inactivation curves than did the linear model. The mean square errors were 0.381 for the log logistic model, 0.425 for the Weibull model, and 1.546 for the linear model. For inactivation as a function of temperature, FCV was most resistant to pressure at 20°C. Temperatures above and below 20°C significantly increased pressure inactivation of FCV. A 4-min treatment of 200 MPa at −10 and 50°C reduced the titer of FCV by 5.0 and 4.0 log units, respectively; whereas at 20°C the same treatment only reduced the titer by 0.3 log units. These novel results point to the potential for using temperatures above and particularly below room temperature to lower the pressure needed to cause the desired level of virus inactivation.