Photoinitiator concentration and modulated photoactivation: influence on polymerization characteristics of experimental composites

Abstract

Abstract This study determined the influence of photoinitiator concentration on polymerization characteristics of experimental composites photoactivated by different methods. Composites based on BisGMA/TEGDMA and 65% of filler were prepared with the concentration of camphorquinone/amine C1-0.5%, C2-1%, C3-1.5%, and photocured using 4 methods: High-intensity (HI), Low-intensity (LI), Soft-start (SS) and Pulse-delay (PD). Were determined the degree of conversion (DC), depth of cure (DCure) and crosslink density (CLD). Data were submitted to ANOVA and Tukey’s test (p < 0.05). DC and DCure revealed that there were no differences among the photoactivation methods. C3 and C2 showed higher DC than C1. The CLD evaluation revealed considerable differences among the photoactivation methods. Photoinitiator concentration is a determinant factor in the polymerization characteristics of composites. Composite with low photoinitiator concentration show decreased DC and DCure, when compared with the composites with higher concentrations. Photoactivation methods had no effect on the DC and DCure. However, photoactivation methods showed differences when CLD was tested for composites with higher concentration of photoinitiators.