Structural system yielding minimum differences between ordinary and staged analyses

Abstract

AbstractStructural engineers should appropriately design concrete structures to resist lateral loads. Determining the adequate system for resisting the expected lateral loads is important to control the building drift. Choosing the appropriate system is usually conducted assuming the predicted forces are applied to completed concrete buildings at one step which is commonly known as ordinary analysis (OA). Nevertheless, these structures are constructed sequentially which requires using staged analysis (SA) instead of OA. In this paper, a comprehensive numerical model for SA of concrete buildings, which accounts for time dependent effects, is utilized using a well-validated commercial software. Six reinforced concrete buildings with 10 and 20 storeys are analyzed using the developed model. Three various structural systems are considered (Rigid Frame (RF), Shear Wall (SW), and Wall Frame (WF). A comparison is conducted between the displacements and internal forces in beams and slabs obtained from the SA and OA. For a 10-storeys RF building, maximum bending moment from SA is 29.9% higher than that from OA. The same conclusion was observed for the maximum shearing force with a percentage of 19.6%. Moreover, maximum bending moments and shearing forces from SA for the 20-storeys RF building are, respectively, 35.0% and 23.5% larger than those from OA. The RF and WF systems provided the minimum difference in differential displacement between the OA and SA analyses. The RF system produced the least differences in internal forces from OA and SA for all studied buildings.