Investigation of the optimum conditions for electricity generation by haloalkaliphilic archaeon Natrialba sp. GHMN55 using the Plackett–Burman design: single and stacked MFCs

Abstract

AbstractThe production of bioelectricity via the anaerobic oxidation of organic matter by microorganisms is recently receiving much interest and is considered one of the future alternative technologies. In this study, we aimed to produce electrical current by using facultative halophilic archaeon Natrialba sp. GHMN55 as a biocatalyst at the anode of a microbial fuel cell (MFC) to generate electrons from the anaerobic breakdown of organic matter to produce electrical current. Since the MFC’s performance can be affected by many factors, the Plackett–Burman experimental design was applied to optimize the interaction between these factors when tested together and to identify the most significant factors that influence bioelectricity generation. We found that the factors that significantly affected electrical current generation were casein, inoculum age, magnet-bounded electrodes, NaCl, resistor value, and inoculum size; however, the existence of a mediator and the pH showed negative effects on bioelectricity production, where the maximum value of the 200 mV voltage was achieved after 48 h. The optimum medium formulation obtained using this design led to a decrease in the time required to produce bioelectricity from 20 days (in the basal medium) to 2 days (in the optimized medium). Also, the overall behavior of the cell could be enhanced by using multiple stacked MFCs with different electrical configurations (such as series or parallel chambers) to obtain higher voltages or power densities than the single chambers where the series chambers were recorded at 27.5 mV after 48 h of incubation compared with 12.6 mV and 1.1 mV for parallel and single chambers, respectively. These results indicate that the order of preferred MFC designs regarding total power densities would be series > parallel > single.