Wavelength-Invariant Resist Composed of Bimetallic Layers

Abstract

ABSTRACTTwo layer co-sputtered Bi over In thin films (40 nm/layer) act as a microfabrication resist with many potential applications. Their physical, chemical and optical characteristics change after laser exposures that produce a rapid thermal anneal in selected areas. Unlike organic photoresists, Bi/In is a bimetallic thermal resist whose sensitivity shows a near wavelength invariance for wavelengths from Near IR to UV. The laser-induced patterns are developed by an etch that selectively removes unexposed areas and retains converted ones. The optical density (OD) of 40 nm thick Bi/In films on quartz substrates, for example, changes from 3.3 OD to 0.37 OD in the annealed area. This has enabled the creation of direct-write photomasks for standard photoresist exposures. In this paper, the composition, morphology, and nanostructure of the resist before and after laser processing were studied in order to determine the mechanism of the laser-induced material conversion. AFM, XRD, and TEM show that the as-deposited films are polycrystalline, continuous, but with a rough, island morphology. Furnace anneals in air above the eutectic temperature (150–250°C, 3 hours) result in the formation of the tetragonal phase BiIn with a small degree of oxidation. The island morphology is maintained but there is evidence of melting and recrystallization. Transparency is much lower than after laser annealing. RBS and NRA depth profile analysis show that Bi/In films exposed to laser annealing in air contain a large fraction of oxygen and suggest that the converted film may be a BiIn0.6O6 /Bi0.3InO6 bilayer.