An Improved Fick’s Law Algorithm Based on Dynamic Lens-Imaging Learning Strategy for Planning a Hybrid Wind/Battery Energy System in Distribution Network

Abstract

In this paper, optimal and multi-objective planning of a hybrid energy system (HES) with wind turbine and battery storage (WT/Battery) has been proposed to drop power loss, smooth voltage profile, enhance customers reliability, as well as minimize the net present cost of the hybrid system plus the battery degradation cost (BDC). Decision variables include the installation site of the hybrid system and size of the wind farm and battery storage. These variables are found with the help of a novel metaheuristic approach called improved Fick’s law algorithm (IFLA). To enhance the exploration performance and avoid the early incomplete convergence of the conventional Fick’s law (FLA) algorithm, a dynamic lens-imaging learning strategy (DLILS) based on opposition learning has been adopted. The planning problem has been implemented in two approaches without and considering BDC to analyze its impact on the reserve power level and the amount and quality of power loss, voltage profile, and reliability. A 33-bus distribution system has also been employed to validate the capability and efficiency of the suggested method. Simulation results have shown that the multi-objective planning of the hybrid WT/Battery energy system improves voltage and reliability and decreases power loss by managing the reserve power based on charging and discharging battery units and creating electrical planning with optimal power injection into the network. The results of simulations and evaluation of statistic analysis indicate the superiority of the IFLA in achieving the optimal solution with faster convergence than conventional FLA, particle swarm optimization (PSO), manta ray foraging optimizer (MRFO), and bat algorithm (BA). It has been observed that the proposed methodology based on IFLA in different approaches has obtained lower power loss and more desirable voltage profile and reliability than its counterparts. Simulation reports demonstrate that by considering BDC, the values of losses and voltage deviations are increased by 2.82% and 1.34%, respectively, and the reliability of network customers is weakened by 5.59% in comparison with a case in which this cost is neglected. Therefore, taking into account this parameter in the objective function can lead to the correct and real calculation of the improvement rate of each of the objectives, especially the improvement of the reliability level, as well as making the correct decisions of network planners based on these findings.