Evaluation of Workpiece Temperature during Drilling of GLARE Fiber Metal Laminates Using Infrared Techniques: Effect of Cutting Parameters, Fiber Orientation and Spray Mist Application-Reference-Cited by-同舟云学术

Evaluation of Workpiece Temperature during Drilling of GLARE Fiber Metal Laminates Using Infrared Techniques: Effect of Cutting Parameters, Fiber Orientation and Spray Mist Application

Published:2016-07-28 Issue:8 Volume:9 Page:622
ISSN:1996-1944
Container-title:Materials
language:en
Short-container-title:Materials

Author:

Giasin Khaled,Ayvar-Soberanis Sabino

Publisher

MDPI AG

Subject

General Materials Science

Link

http://www.mdpi.com/1996-1944/9/8/622/pdf

Reference69 articles.

1. Fibre Metal Laminates: An Introduction;Vlot,2001

2. Machinability of Carbon-Fiber-Reinforced and GLARE Materials

3. Abrasive water jet machining of glass fibre metal laminates

4. Abrasive waterjet machining effects on kerf quality in thin fiber metal laminate;Ramulu,2015

Cited by 40 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Evaluating the optimum abrasive water jet machinability for CARALL composites with various fiber orientations;Polymer Composites;2024-04-24

2. Influence of cutting tool design on ultrasonic-assisted drilling of fiber metal laminates;The International Journal of Advanced Manufacturing Technology;2024-03-06

3. Multiscale modelling and experimental analysis of ultrasonic-assisted drilling of GLARE fibre metal laminates;Composites Part A: Applied Science and Manufacturing;2024-02

4. Towards an Advanced Modeling of Hybrid Composite Cutting: Heat Discontinuity at Interface Region;Polymers;2023-04-20

5. Impact of cooled compressed air and high-speed cutting on the drilling of hybrid composite-metal stacks;The International Journal of Advanced Manufacturing Technology;2023-02-16