Different Primary Gas Flow Rates in Determining the Flattening Behavior of In-Flight Particles in Plasma-Sprayed NiCrBSi Coatings and the Resultant Microstructure and Hardness

Abstract

The flattening behavior of in-flight particles during plasma spraying is a highly intricate process affected by numerous factors. Therefore, in this work, in-flight particles (spherical NiCrBSi powder) were collected with the water quenching process, and the morphology and composition differences between the original powder particles and the melted in-flight particles were observed using scanning electron microscopy (SEM). The particle size in various states was recorded and calculated. The internal structure of the particles was analyzed to elucidate their morphology and compositions under different flow rates of primary gas (FRPG). A coating with 1.25% porosity and a hardness of 767 HV0.5 was achieved at the FRPG of 80 L/min. X-ray diffraction (XRD) and transmission electron microscopy (TEM) were used to characterize the microstructures of the obtained coatings. It was found that the as-sprayed coating had a certain amount of the amorphous phase. A noteworthy correlation was also established, wherein a decreased distance from the substrate, augmented spraying passes, and reduced amorphous phase content were interrelated. Concurrently, a noticeable influence of the tamping effect exerted by the in-flight particles on the coating was observed.