Annealing Heat Treatment for Homogenizing the Microstructure and Mechanical Properties of Electron-Beam-Welded Thick Plate of Ti-6Al-4V Alloy

Abstract

In the application of Ti-6Al-4V to aerospace structural components, when welding thick plates similar of the thickness of the components, microstructure and hardness gradients emerge between the base material (BM) and the joint. This leads to the issue of significant stress concentration in the BM under tensile stress. To address this problem through post-welding heat treatment, this study conducted heat treatments at temperatures both below (mill annealing, MA) and above the beta-transus temperature (beta annealing, BA) on electron-beam weldments of 18 mm thickness Ti-6Al-4V plates. Subsequently, microstructures and hardness were analyzed at different depths from the upper surface and areas (fusion zone (FZ), heat-affected zone (HAZ), and BM), and tensile properties were measured at various depths. The results indicated that α′ observed in FZ and HAZ was resolved through both MA and BA. Particularly after BA, the microstructural gradient that persisted even after MA completely disappeared, resulting in the homogenization of widmanstätten α + β. Consequently, after BA, the hardness gradient in each zone also disappeared, and the tensile strength was higher than in just-welded and MA heat-treated plates.