Single-Sided Microwave Near-Field Scanning of Pine Wood Lumber for Defect Detection

Abstract

Defects and cracks in dried natural timber (relative permittivity 2–5) may cause structural weakness and enhanced warping in structural beams. For a pine wood beam (1200 mm × 70 mm × 70 mm), microwave reflection (S11) and transmission (S21) measurements using a cavity-backed slot antenna on the wood surface showed the variations caused by imperfections and defects in the wood. Reflection measurements at 4.4 GHz increased (>5 dB) above a major knot evident on the wood surface when the E-field was parallel to the wood grain. Similar results were observed for air cavities, independent of depth from the wood surface. The presence of a metal bolt in an air hole increased S11 by 2 dB. In comparison, transmission measurements (S21) were increased by 6 dB for a metal screw centered in the cavity. A kiln-dried pine wood sample was saturated with water to increase its moisture content from 17% to 138%. Both parallel and perpendicular E-field measurements showed a difference of more than 15 dB above an open saw-cut slot in the water-saturated beam. The insertion of a brass plate in the open slot created a 7 dB rise in the S11 measurement (p < 0.0003), while there was no significant variation for perpendicular orientation. By measuring the reflection coefficient, it was possible to detect the location of a crack through a change in its magnitude without a noticeable change (<0.01 GHz) in resonant frequency. These microwave measurements offer a simple, single-frequency non-destructive testing method of structural timber in situ, when one or more plane faces are accessible for direct antenna contact.