Abstract
The paper deals with the behavior of the rotary ultrasonic machining process at different cutting speeds of ceramic materials. This process is relatively new; therefore, there are gaps in information about its behavior at near-critical parameters. We adjusted cutting speeds 10 times lower and 10 times higher than the recommended one. The observed parameters were machine load, tool wear, and surface roughness. Alumina and zirconia ceramics were used as materials. The results will help with the optimization of the cutting parameters of the rotary ultrasonic machining process.
Funder
Vedecká Grantová Agentúra MŠVVaŠ SR a SAV
Subject
Electrical and Electronic Engineering,Industrial and Manufacturing Engineering,Control and Optimization,Mechanical Engineering,Computer Science (miscellaneous),Control and Systems Engineering
Reference47 articles.
1. The Effects of Ultrasonic Vibration Parameters on Machining Performance in Turning of Mild Steels. Int. Conf. on Advances in Materials and Processing Technologies, PTS ONE AND TWO;Celaya;AIP Conf. Proc.,2010
2. Improvement of turning and drilling by ultrasonic assistance;Celaya,2008
3. Ultrasonic Assisted Turning of mild steels
4. Analysis of Machinability of Ti- and Ni-Based Alloys
5. Experimental analysis on autoresonant control of ultrasonically assisted drilling
Cited by
1 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献