Affiliation:
1. School of Mechanical and Electronic Engineering, Shandong University of Science and Technology, Qingdao 266590, China
2. School of Information Science and Engineering, Shandong Normal University, Jinan 250358, China
3. School of Energy and Mining Engineering, Shandong University of Science and Technology, Qingdao 266590, China
Abstract
A hydraulic support is one of the key pieces of equipment in a fully mechanized coal-mining face. The shaft is seriously worn due to repeated support shifting in coal-mining operations, and the hydraulic support bears a large amount of impact load in the support process, leading to a threat to its dynamic stability. In order to study the impact load on the posture and dynamics of a hydraulic support, and considering the joint clearance of the hydraulic-support hinge point, based on the dynamics software Adams, the equivalent variable-stiffness damping system is used to replace the column, and the impact analysis model of the hydraulic support with joint clearance is established. The roof pressure is vertically applied to the load balance area of the top beam by static load, and the impact load is vertically applied to the top beam downward. Based on the above model, considering the different distributions of joint clearance, research about the influence of joint clearance on the posture and dynamic characteristics of the hydraulic support is carried out. The results show that when there is joint clearance on both sides of the hydraulic support, when the top beam bears the impact load, the X-axis PMR (position movement ratio) at different positions of the top beam is more than 80%, and the forward-tilt posture is obvious. When the hydraulic support has only unilateral clearance, the front end of the top beam bears the impact load, and the front end of the top beam moves laterally, while the rear end of the top beam mainly moves longitudinally. When the end of the top beam bears the impact load, the vertical PMR of the top beam is less than 1%. When the impact load acts on the side with joint clearance, the top beam has a certain degree of lateral offset, and the offset directions on both sides of the top beam are inconsistent. At this time, the top beam presents a torsional-bearing posture. When the front end of the top beam is loaded, the mechanical curve of each hinge point is higher than the rear-end load. For the hinge point on the side without clearance, the maximum load-fluctuation coefficient reaches 1.04, while for the hinge point on the side with clearance, the minimum load is 0 kN, which will mean some hinge points cannot to play a supporting role. The analysis results will be helpful to research hydraulic supports considering joint clearance.
Funder
National Natural Fund
Natural Science Foundation of Shandong Province
Subject
Electrical and Electronic Engineering,Industrial and Manufacturing Engineering,Control and Optimization,Mechanical Engineering,Computer Science (miscellaneous),Control and Systems Engineering
Reference26 articles.
1. Supporting Condition Acquisition and Fuzzy Comprehensive Evaluation Method for Hydraulic Support;Du;J. China Coal Soc.,2017
2. Conception for Strata Control and Intelligent Mining Technology in Deep Coal Mines with Depth More than 1000 m;Kang;J. China Coal Soc.,2018
3. Development Course and Prospect of the 50 Years’ Comprehensive Mechanized Coal Mining in China;Yan;Coal Sci. Technol.,2021
4. A Holistic Examination of the Load Rating Design of Longwall Shields after More than Half a Century of Mechanised Longwall Mining;Frith;Int. J. Min. Sci. Technol.,2015
5. Hydraulic Support and Coal Wall Coupling Relationship in Ultra Large Height Mining Face;Wang;J. China Coal Soc.,2017
Cited by
6 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献