Experimental and Theoretical Investigations on Diamond Wire Sawing for a NdFeB Magnet

Abstract

The normal processing of sintered NdFeB magnets, used in many applied fields, involves diamond wire sawing. Due to the fact of its relatively lower hardness and high brittleness, the surface roughness and periodic waviness of the sawed surface have become a serious problem, but the surface formation mechanism is still unknown. In this work, a diamond wire sawing experiment with a NdFeB magnet was conducted while both the cutting force and the diamond wire lateral displacement were monitored. The vibration, the lateral swing of the wire and the cutting force were thoroughly analyzed. After the experiment, the surface morphology was carefully inspected under both a white light interferometer and SEM. It was discovered that the lateral swing of the diamond wire was the main cause of the periodic waviness on the surface, the PV of which was positively proportional to the normal cutting force. The surface morphology and surface roughness along the saw mark revealed that the vibration impact of ploughing/rubbing grits can induce the NdFeB grain to loosen off and cause more brittle fractures when the feed rate was 0.05 mm/min under wet cutting.