Abstract
The design of modern semiconductor devices often requires the fabrication of three-dimensional (3D) structures to integrate microelectronic components with photonic, micromechanical, or sensor systems within one semiconductor substrate. It is a technologically challenging task, as a strictly defined profile of the device structure is obligatory. This can be achieved either by chemical etching or selective deposition on a masked substrate. In this paper, the growth uniformity of AlGaN/GaN heterostructures during selective-area metalorganic vapour-phase epitaxy (SA-MOVPE) was studied. Such structures are typically used in order to fabricate high-electron-mobility transistors (HEMT). The semiconductor material was deposited through 200 μm long stripe-shaped open windows in a SiO2 mask on GaN/sapphire templates. The window width was varied from 5 μm to 160 μm, whereas mask width separating particular windows varied from 5 μm to 40 μm. The experiment was repeated for three samples differing in GaN layer thickness: 150 nm, 250 nm, and 500 nm. Based on theoretical models of the selective growth, a sufficiently uniform thickness of epitaxially grown AlGaN/GaN heterostructure has been achieved by selecting the window half-width that is smaller than the diffusion length of the precursor molecules. A Ga diffusion length of 15 μm was experimentally extracted by measuring the epitaxial material agglomeration in windows in the dielectric mask. Measurements were conducted while using optical profilometry.
Subject
Electrical and Electronic Engineering,Computer Networks and Communications,Hardware and Architecture,Signal Processing,Control and Systems Engineering
Cited by
5 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献