Experimental study on the penetration interfaces of pipes with different cross-sections in overflow water-assisted coinjection molding-Reference-Cited by-同舟云学术

Experimental study on the penetration interfaces of pipes with different cross-sections in overflow water-assisted coinjection molding

Published:2015-09-15 Issue:1 Volume:133 Page:n/a-n/a
ISSN:0021-8995
Container-title:Journal of Applied Polymer Science
language:en
Short-container-title:J. Appl. Polym. Sci.

Author:

Kuang Tang-Qing¹,Zhou Kai¹,Wu Li-Xuan²,Zhou Guo-Fa³,Turng Lih-Sheng⁴

Affiliation:

1. Department of Material Science and Engineering, School of Mechanical and Electrical Engineering; East China Jiaotong University; Nanchang 330013 China

2. Technology Development Center for Polymer Processing Engineering of Guangdong Province; Guangdong Industry Technical College; Guangzhou 510300 China

3. School of Environmental and Chemical Engineering; Nanchang University; Nanchang 330000 China

4. Polymer Engineering Center and Wisconsin Institute for Discovery; University of Wisconsin-Madison; Madison Wisconsin 53706

Funder

National Natural Science Foundation of China

China Scholarship Council

Science and Technology Association of Jiangxi Province

the Wisconsin Institute for Discovery (WID) at the University of Wisconsin-Madison

Opening Project of Technology Development Center for Polymer Processing Engineering of Guangdong Province

Publisher

Wiley

Subject

Materials Chemistry,Polymers and Plastics,Surfaces, Coatings and Films,General Chemistry

Reference25 articles.

1. Two-component water assisted injection moulding

2. Water assisted injection moulding: development of insights and predictive capabilities through experiments on instrumented process in parallel with computer simulations

3. The manufacturing of thermoplastic composite parts by water-assisted injection-molding technology

4. Properties enhancement of short glass fiber-reinforced thermoplastics via sandwich injection molding

Cited by 9 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Study of Residual Wall Thickness and Multiobjective Optimization for Process Parameters of Water-Assisted Injection Molding;Advances in Polymer Technology;2020-12-10

2. The study of short‐shot water‐assisted injection molding of short glass fiber reinforced polypropylene;Journal of Applied Polymer Science;2020-07-13

3. Numerical Simulation during Short-Shot Water-Assisted Injection Molding Based on the Overflow Cavity for Short-Glass Fiber-Reinforced Polypropylene;Advances in Polymer Technology;2020-05-05

4. Optimization of Residual Wall Thickness Uniformity in Short-Fiber-Reinforced Composites Water-Assisted Injection Molding Using Response Surface Methodology and Artificial Neural Network-Genetic Algorithm;Advances in Polymer Technology;2020-02-26

5. Effect of Process Parameters on Short Fiber Orientation along the Melt Flow Direction in Water-Assisted Injection Molded Part;Advances in Materials Science and Engineering;2019-08-19