Microstructure and tensile properties of injection molded thermoplastic polyurethane with different melt temperatures-Reference-Cited by-同舟云学术

Microstructure and tensile properties of injection molded thermoplastic polyurethane with different melt temperatures

Published:2020-01-02 Issue:29 Volume:137 Page:48891
ISSN:0021-8995
Container-title:Journal of Applied Polymer Science
language:en
Short-container-title:J Appl Polym Sci

Author:

Xiang Ning¹^ORCID,Zhang Xiaowen¹,Zheng Mengyao¹,Ge Yong¹,Wang Tao¹,Liu Haibao²,Maharaj Chris³,Dear John P.²,Yan Yue¹

Affiliation:

1. Beijing Institute of Aeronautical Materials, AECCBeijing Engineering Research Centre of Advanced Structural Transparencies for the Modern Traffic System Beijing 100095 China

2. Department of Mechanical EngineeringImperial College London London SW7 2AZ United Kingdom

3. Department of Mechanical and Manufacturing EngineeringThe University of the West Indies St. Augustine Trinidad and Tobago

Publisher

Wiley

Subject

Materials Chemistry,Polymers and Plastics,Surfaces, Coatings and Films,General Chemistry

Link

https://onlinelibrary.wiley.com/doi/pdf/10.1002/app.48891

Reference39 articles.

1. Influence of the prepolymerization on the properties of thermoplastic polyurethane elastomers. Part I. Prepolymer characterization

2. Maximizing the utility of bio-based diisocyanate and chain extenders in crystalline segmented thermoplastic polyester urethanes: Effect of polymerization protocol

3. Synthesis, structure and properties of fully biobased thermoplastic polyurethanes, obtained from a diisocyanate based on modified dimer fatty acids, and different renewable diols

4. The influences of deformation state and experimental conditions on inelastic behaviour of an extruded thermoplastic polyurethane elastomer

5. Synthesis and characterization of an ultra-soft poly(carbonate urethane)

Cited by 10 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Combining Injection Molding and 3D Printing for Tailoring Polymer Material Properties;Macromolecular Materials and Engineering;2024-08-09

2. Optimizing TPU performance: The role of mold temperature on injection molding of TPU;Journal of Applied Polymer Science;2024-04-12

3. Three-Dimensional Piezoelectric–Triboelectric Hybrid Nanogenerators for Mechanical Energy Harvesting;ACS Applied Nano Materials;2023-08-16

4. Long-Term In Vivo Response of a Polyurethane Gastric Implant for Treating Gastro-Oesophageal Reflux Diseases: A Comparison of Different Surface Treatments;Biomedical Materials & Devices;2022-12-02

5. Preparation of laminated safety glass based on high strength polyurethane film by solution annealing;Journal of Applied Polymer Science;2022-10-31