Influence of manufacturing induced defects on damage initiation and propagation in carbon/epoxy NCF laminates-Reference-Cited by-同舟云学术

Influence of manufacturing induced defects on damage initiation and propagation in carbon/epoxy NCF laminates

Published:2015-01-02 Issue:1 Volume:1 Page:44-53
ISSN:2055-0340
Container-title:Advanced Manufacturing: Polymer & Composites Science
language:en
Short-container-title:Advanced Manufacturing: Polymer & Composites Science

Author:

Carraro P. A.¹,Maragoni L.¹,Quaresimin M.¹

Affiliation:

1. Università degli Studi di Padova – Dipartimento di Tecnica e Gestione dei Sistemi Industriali, Stradella San Nicola 3, 36100 Vicenza, Italy

Publisher

Informa UK Limited

Subject

Management of Technology and Innovation,Electrical and Electronic Engineering,Polymers and Plastics

Link

https://www.tandfonline.com/doi/pdf/10.1179/2055035914Y.0000000004

Reference39 articles.

1. Experimental investigation of flow-induced microvoids during impregnation of unidirectional stitched fiberglass mat

2. Formation of microvoids during resin-transfer molding process

3. Correlation of void distribution to VARTM manufacturing techniques

4. Effects of vacuum pressure, inlet pressure, and mold temperature on the void content, volume fraction of polyester/e-glass fiber composites manufactured with VARTM process

5. AspL. E. and BrandtF. ‘Effects of pores and voids on the interlaminar delamination toughness of a carbon/epoxy composite’, Proc. ICCM11, Gold Coast, Queensland, Australia, July 1997, 322–331.

Cited by 44 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Efficient defect reconstruction from temporal non-uniform pulsed thermography data using the virtual wave concept;NDT & E International;2024-10

2. Experimental characterization and cyclic cohesive zone modeling of mode I delamination growth in glass/epoxy composite laminates under high cycle fatigue;Engineering Fracture Mechanics;2024-02

3. Modeling formation and evolution of voids in unsaturated dual scale preforms in Resin Transfer Molding processes;Composites Part A: Applied Science and Manufacturing;2023-10

4. Formation of non-uniform fibre distributions in winding-pultrusion process and its effect on axial compressive properties of hollow GFRP profiles;Composites Part A: Applied Science and Manufacturing;2023-10

5. An analytical approach to model transverse inter-fibre fracture evolution in cross-ply carbon fibre reinforced polymers laminates under a three-point bending test;Journal of Composite Materials;2023-06-15