Analysis of hydraulic components using computational fluid dynamics models

Abstract

This paper presents some results obtained during the computational fluid dynamics (CFD) analysis of internal flows inside a hydraulic component, using a scaling technique applied to numerical pre- and post-processing. The main aim of the work is to demonstrate the reduction of computational work needed for a complete analysis of component behaviour over a wide range of operating conditions. This result is achieved through the adoption of a methodology aimed at giving the highest level of generality to a non-dimensional solution, thereby overcoming the two major limitations encountered in the use of CFD in fluid power design: computer resources and time. In the case study, the technique was applied to a hydraulic distributor and computations were performed with a commercial computational fluid dynamics code. The key factor of this technique is the evaluation, for a given distributor opening, of the Reynolds number of the flow in the metering region. Provided that this number is high enough to ensure that the discharge coefficient has reached its asymptotic value, the characterization of the flow by a single non-dimensional numerical run can be shown. The theoretical contents of the analysis of the re-scaling technique, which focuses on the engineering information necessary in component design, are described in detail. The bases for its subsequent application to actual cases are then outlined. Finally, a fairly close correlation between numerical results and experimental data is presented.