Contacting paper-based supercapacitors to printed electronics on paper substrates

Abstract

Abstract Hybrid printed electronics, in which printed structures and silicon-based components co-exist will likely be among the first commercial solutions. In this case the paper substrate acts much in the same way as circuit boards, containing conductive tracks and acting as a carrier for the electrical components. It is important to consider the contacting of the components to be able to produce low resistance electrical contacts to the conductive tracks. Supercapacitors are able to deliver a large amount of current in a short time and are a good option for short term energy storage and if the printed product is to be used only one, or a few times, it can be the only power source needed. When manufacturing printed electronics, the overall resistance of the printed tracks as well as the contact resistance of the mounted components will add up to the total resistance of the system. A high resistance will cause a voltage drop from the power source to the component. This will waste power that goes to Joule heating and also the voltage and current available to components may be too low to drive them. If the intention is to use a power supply such as batteries or solar cells this becomes a limitation. In this article have been tested several conductive adhesives used to contact paper based supercapacitors to ink jet printed silver tracks on paper. The best adhesive gives about 0.3 Ω per contact, a factor 17 better compared to the worst which gave 5 Ω. The peak power that is possible to take out from a printed system with a flexible battery and super capacitors is about 10 times higher than compared with the same system with only the battery.