Development of Temperature-Compensated Catheter Flow Sensor for Measuring Reciprocating Air Flows in Bronchial Pathways-Reference-Cited by-同舟云学术

Development of Temperature-Compensated Catheter Flow Sensor for Measuring Reciprocating Air Flows in Bronchial Pathways

Published:2014 Issue:6 Volume:134 Page:126-131
ISSN:1341-8939
Container-title:IEEJ Transactions on Sensors and Micromachines
language:en
Short-container-title:IEEJ Trans. SM

Author:

Matsuyama Takuya¹,Yamazaki Yudai¹,Matsushima Miyoko²,Kawabe Tsutomu²,Shikida Mitsuhiro¹

Affiliation:

1. Department of Micro-Nano Systems Engineering, Graduate School of Engineering, Nagoya University

2. Department of Radiological and Medical Laboratory Sciences, Graduate School of Medicine, Nagoya University

Publisher

Institute of Electrical Engineers of Japan (IEE Japan)

Subject

Electrical and Electronic Engineering,Mechanical Engineering

Link

https://www.jstage.jst.go.jp/article/ieejsmas/134/6/134_126/_pdf

Reference17 articles.

1. (1) P. Griss and G. Stemme : “Novel, side opened out-plane microneedles for micro-fluidic transdermal interfacing”, Tech. Digest. MEMS 2002, Las Vegas, USA, pp. 467-470 (2002)

2. (2) N. Roxhed, P. Griss, and G. Stemme : “Reliable in-vivo Penetration and Transdermal Injection using Ultra-Sharp Hollow Microneedles”, Tech. Digest. Transducers 2005, Seoul, Korea, pp. 213-216 (2005)

3. (3) A. Trautmann, P. Ruther, and O. Paul : “Microneedle arrays fabricated using suspended etch mask technology combined with fluidic through wafer vias”, Tech. Digest. MEMS 2003, Kyoto, Japan, pp. 682-685 (2003)

4. (4) J. G. E. Gardeniers, J. W. Berenschot, M. J. de Boer, Y. Yeshurun, M. Hefetz, R. van't Oever, and A. van den Berg : “Silicon micromachined hollow microneedles for transdermal liquid transfer”, Tech. digest. MEMS 2002, Las Vegas, USA, pp. 114-114 (2002)

5. (5) M. Shikida, M. Ando, Y. Ishihara, T. Ando, K. Sato, and K. Asaumi : “Non-photolithographic pattern transfer for fabricating pen-shaped microneedle structures”, Journal of Micromechanics and Microengineering, Vol. 14, pp. 1462-1467 (2004)