Quantifying influence of drilling additional boreholes on quality of geological model

Abstract

Geotechnical stability analysis in open-pit mines requires access to a representative geotechnical model. The confidence level in the collected geotechnical data influences slope design. This paper investigates the influence of the number of boreholes, drilled to collect geological information, on the quality of one component of the geotechnical model, the geological model. The number of boreholes influences the number of rock core samples collected for the identification of rock type, and the definition of geotechnical domains and their boundaries within the rock mass. A challenge in the definition of the geotechnical domains is the determination of the drill hole density that minimizes the variation in the interpreted geological model from the actual rock mass. To quantify the influence of the drill hole density, boreholes are simulated in the most recently updated geological model for three mine sites. The simulated drill hole density is increased progressively until the variation of the interpreted section, compared with the original section, is minimized. A classification strategy was developed to determine the complexity level for each geotechnical domain. Furthermore, a series of empirical quantitative guidelines are presented prescribing the minimum drill hole density per domain complexity, while limiting variations from the actual rock mass.