Pressure Barrier Applicability to Polymer Flood Design

Abstract

Abstract Effective oil displacement from a reservoir requires adequate and properly directed pressure gradients in areas of high oil saturation. If the polymer bank is too large or too viscous during a polymer flood, the pressure drop from the injection well to the polymer front may act as a pressure barrier by usurping most of the downstream driving force for oil displacement. Polymer injection pressures must be limited. The maximum allowable injection pressure is commonly constrained by caprock integrity, injection equipment, and/or regulations, even though fractures can be beneficial to polymer injectivity (and even sweep efficiency in some cases). This paper examines when the pressure-barrier concept limits the size and viscosity of the polymer bank during a polymer flood. Both analytical and numerical methods are used to address this issue. We examine the relevance of the pressure barrier concept for a wide variety of circumstances, including oil viscosities ranging from 10-cp (like at Daqing, China) to 1650-cp (like at Pelican Lake, Alberta), vertical wells (like at Tambaredjo, Suriname) versus horizontal wells (like at Milne Point, Alaska), single versus multiple layered reservoirs, permeability contrast, and with versus with crossflow between layers. We also examine the relation between the pressure-barrier concept and fractures and fracture extension during polymer injection. We demonstrate that in reservoirs with single layers, the pressure-barrier concept only limits the optimum viscosity of the injected polymer if the mobility of the polymer bank is less than the mobility of the displaced oil bank. The same is true for multi-zoned reservoirs with no crossflow between layers. Thus, for these cases, the optimum polymer viscosity is likely to be dictated by the mobility of the oil bank, unless other factors (like fracture extension) intervene. For multi-zoned reservoirs with free crossflow between layers, the situation is different. A compromise must be reached between injected polymer viscosity and the efficiency of oil recovery. The relevance of our findings is applied to operations for several existing polymer floods. This work is particularly relevant to viscous-oil reservoirs (like Pelican Lake and others) where the injected polymer viscosities are substantially lower than the oil viscosity