Evaporation and mixture formation characteristics of diesel spray under various nozzle hole size and injection pressure condition employing similar injection rate profile-Reference-Cited by-同舟云学术

Evaporation and mixture formation characteristics of diesel spray under various nozzle hole size and injection pressure condition employing similar injection rate profile

Published:2021-04 Issue: Volume:123 Page:105184
ISSN:0735-1933
Container-title:International Communications in Heat and Mass Transfer
language:en
Short-container-title:International Communications in Heat and Mass Transfer

Author:

Safiullah ,Nishida Keiya,Ogata Youichi

Publisher

Elsevier BV

Subject

Condensed Matter Physics,General Chemical Engineering,Atomic and Molecular Physics, and Optics

Reference30 articles.

1. Diesel engines: environmental impact and control;Lloyd;J. Air Waste Manage. Assoc.,2001

2. A comparison of computational fluid dynamics predicted initial liquid penetration using rate of injection profiles generated using two different measurement techniques;Ge;Int. J. Eng. Res.,2019

3. Effect of laser induced plasma ignition timing and location on diesel spray combustion;Pastor;Energy Convers. Manag.,2017

4. Influence of fuel properties on the diesel injection process in nonvaporizing conditions;Dernotte;At Sprays.,2012

5. Development of a new measurement tool for fuel injection rate in diesel engines;Takamura;SAE Trans.,1989

Cited by 15 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Effects of Nozzle Configuration on Efficiency of Direct-Contact Gas-Vapor Mixture Generators;Известия Российской академии наук. Энергетика;2024-07-07

2. Characterization of diesel spray with novel high-speed laser absorption scattering technique under diesel engine-like condition;International Journal of Heat and Mass Transfer;2024-05

3. Macroscopic and microscopic spray characterisation of Low-Octane blends for gasoline compression ignition engines;Fuel;2024-04

4. Quantitative analysis of transient evaporation characteristics in diesel spray by high-speed UV-LAS technique;International Journal of Multiphase Flow;2024-02

5. Optimization Design of Nozzle Structure Inside Boiler Based on Orthogonal Design;Processes;2023-10-07