Prediction of springback in air-bending of Advanced High Strength steel (DP780) considering Young׳s modulus variation and with a piecewise hardening function-Reference-Cited by-同舟云学术

Prediction of springback in air-bending of Advanced High Strength steel (DP780) considering Young׳s modulus variation and with a piecewise hardening function

Published:2016-01 Issue: Volume:105 Page:266-272
ISSN:0020-7403
Container-title:International Journal of Mechanical Sciences
language:en
Short-container-title:International Journal of Mechanical Sciences

Author:

Yang Xi^ORCID,Choi Changhyok,Sever Nimet Kardes,Altan Taylan

Publisher

Elsevier BV

Subject

Mechanical Engineering,Mechanics of Materials,Condensed Matter Physics,General Materials Science,Civil and Structural Engineering

Reference16 articles.

1. A general analytic solution for plane strain bending under tension for strain-hardening material at large strains;Alexandrov;Arch Appl Mech,2011

2. The bending moment and springback in pure bending of anisotropic sheets;Alexandrov;Int J Solids Struct,2009

3. An effective analytical model for springback prediction in straight flanging processes;Buranathiti;Int J Mater Prod Technol,2004

4. Analysis of the decrease of the apparent Young’s modulus of advanced high strength steels and its effect in bending simulations;Cobo,2009

5. Experimental and numerical studies of springback in air V-bending process for cold rolled trip steels;Fei;Nucl Eng Des,2006

Cited by 65 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Theoretical and experimental investigation of the deformation shape in press-braking bending considering surface residual stresses induced by milling operation;The International Journal of Advanced Manufacturing Technology;2024-02-01

2. In-situ and interrupted cyclic three-point bending tests in SEM of two pearlitic steel microstructures: Lamellar and partially spheroidized;Journal of Materials Research and Technology;2024-01

3. Modelling and prediction of twist springback for UHSS thin-walled component with asymmetric complex section in roll forming process;The International Journal of Advanced Manufacturing Technology;2023-11-04

4. On Orthotropic Elastic Constitutive Modeling for Springback Prediction;Experimental Mechanics;2023-10-17

5. The precise control of end flare with residual stresses of UHSS thin-walled component in roll forming process;Ironmaking & Steelmaking;2023-06-09