Measurement, characterisation and influence of the air temperature above the build plate in fused filament fabrication-Reference-Cited by-同舟云学术

Measurement, characterisation and influence of the air temperature above the build plate in fused filament fabrication

Published:2021-12 Issue: Volume:1 Page:100013
ISSN:2772-3690
Container-title:Additive Manufacturing Letters
language:en
Short-container-title:Additive Manufacturing Letters

Author:

Zhang Jie,Neeckx Jonas,Van Hooreweder Brecht,Ferraris Eleonora

Publisher

Elsevier BV

Reference22 articles.

1. Effect of the Printing Bed Temperature on the Adhesion of Parts Produced by Fused Filament Fabrication;Spoerk;Plastics, Rubber and Composites,2018

2. Effect of Processing Conditions on the Bonding Quality of FDM Polymer Filaments;Sun;Rapid Prototyp. J.,2008

3. Numerical Investigation of the Influence of Process Conditions on the Temperature Variation in Fused Deposition Modeling;Zhang;Materials and Design,2017

4. Heat Transfer-Based Non-Isothermal Healing Model for the Interfacial Bonding Strength of Fused Filament Fabricated Polyetheretherketone;Basgul;Addit. Manuf.,2021

5. Heat Transfer and Adhesion Study for the FFF Additive Manufacturing Process;Lepoivre;Proced. Manuf.,2020

Cited by 5 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Coupled heat transfer–crystallization analysis in continuous carbon fiber-reinforced thermoplastic composites 3D printing: simulation and experimental validation;Progress in Additive Manufacturing;2024-09-10

2. A comprehensive review on shale studies with emphasis on nuclear magnetic resonance (NMR) technique;Gas Science and Engineering;2023-12

3. Geometry Controlled Oscillations in Liquid Crystal Polymer Films Triggered by Thermal Feedback;ACS Applied Materials & Interfaces;2023-03-28

4. Fused-Filament Fabrication of Short Carbon Fiber-Reinforced Polyamide: Parameter Optimization for Improved Performance under Uniaxial Tensile Loading;Polymers;2022-03-23

5. T4F3: temperature for fused filament fabrication;Progress in Additive Manufacturing;2022-03-09