Innovative X-ray diffraction and micromagnetic approaches for reliable residual stress assessment in deep rolled and microfinished AISI 4140 components-Reference-Cited by-同舟云学术

Innovative X-ray diffraction and micromagnetic approaches for reliable residual stress assessment in deep rolled and microfinished AISI 4140 components

Published:2022-09 Issue: Volume:20 Page:2942-2959
ISSN:2238-7854
Container-title:Journal of Materials Research and Technology
language:en
Short-container-title:Journal of Materials Research and Technology

Author:

Strodick Simon^ORCID,Vogel Florian,Tilger Meik,Denstorf Marie,Kipp Monika,Baak Nikolas^ORCID,Kukui Dimitri,Biermann Dirk^ORCID,Barrientos Marina Macias^ORCID,Walther Frank^ORCID

Funder

Ministerium für Kultur und Wissenschaft des Landes Nordrhein-Westfalen

Technische Universität Dortmund

Staatssekretariat für Migration

Deutsche Forschungsgemeinschaft

Publisher

Elsevier BV

Subject

Metals and Alloys,Surfaces, Coatings and Films,Biomaterials,Ceramics and Composites

Reference41 articles.

1. Residual stresses in turning Part I: influence of process parameters;Capello;J Mater Process Technol,2005

2. Determination of residual stresses by X-ray diffraction. Measurement good practice guide;Fitzpatrick;Natl Phys Lab,2005

3. Comparison of two X-ray residual stress measurement methods: sin2 ψ and cos α, through the determination of a martensitic steel X-Ray elastic constant;Delbergue;Mater Res Proc,2017

4. The cosα method for X-ray residual stress measurement using two-dimensional detector;Tanaka;Mechanical Engineering Reviews,2019

5. A conical slit for three-dimensional XRD mapping;Nielsen;J Synchrotron Radiat,2000

Cited by 3 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Deep Rolling Techniques: A Comprehensive Review of Process Parameters and Impacts on the Material Properties of Commercial Steels;Metals;2024-06-04

2. Detection of Phase Transformation during Plastic Deformation of Metastable Austenitic Steel AISI 304L by Means of X-ray Diffraction Pattern Analysis;Metals;2023-05-23

3. Investigation of the Mechanical Properties and Microstructure of the Co40NiCrMo Alloy Used for STACERs and Prepared by the CSPB Process and the Winding and Stabilization Method;Materials;2023-04-08