Optimization of process variables for additive manufactured PLA based tensile specimen using taguchi design and artificial neural network (ANN) technique-Reference-Cited by-同舟云学术

Optimization of process variables for additive manufactured PLA based tensile specimen using taguchi design and artificial neural network (ANN) technique

Published:2021-11 Issue: Volume: Page:
ISSN:2214-7853
Container-title:Materials Today: Proceedings
language:en
Short-container-title:Materials Today: Proceedings

Author:

Teharia Rishabh,Singari Ranganath M.,Kumar Harish

Publisher

Elsevier BV

Subject

General Medicine

Reference28 articles.

1. Wear assessment of 3–D printed parts of PLA (polylactic acid) using Taguchi design and Artificial Neural Network (ANN) technique;Pant;Materials Research Express.,2020

2. Impact of Additive Manufacturing in Value Creation, Methods, Applications and Challenges;Teharia;Advances in Manufacturing and Industrial Engineering: Springer,2021

3. The status, challenges, and future of additive manufacturing in engineering;Gao;Computer-Aided Design.,2015

4. S. Negi S. Dhiman R. Kumar Sharma Basics and applications of rapid prototyping medical models 20 3 2014 2014 256 267

5. Optimisation of FDM process parameters by Taguchi method for imparting customised properties to components;Srivastava;Virtual and Physical Prototyping.,2018

Cited by 16 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. An investigation of the ensemble machine learning techniques for predicting mechanical properties of printed parts in additive manufacturing;Decision Analytics Journal;2024-09

2. Intelligent support in manufacturing process selection based on artificial neural networks, fuzzy logic, and genetic algorithms: Current state and future perspectives;Computers & Industrial Engineering;2024-07

3. Surface Finish Optimization of Vapor Smoothened PLA Fabricated Parts with Microstructural Analysis;Solid State Phenomena;2024-06-11

4. Quantitative Insight into the Compressive Strain Rate Sensitivity of Polylactic Acid, Acrylonitrile Butadiene Styrene, Polyamide 12, and Polypropylene in Material Extrusion Additive Manufacturing;Journal of Dynamic Behavior of Materials;2024-04-11

5. Fabrication and Characterisation of Sustainable 3D-Printed Parts Using Post-Consumer PLA Plastic and Virgin PLA Blends;Processes;2024-04-09