Chip and built-up edge formation in the machining of in situ Al4C3–Al composite-Reference-Cited by-同舟云学术

Chip and built-up edge formation in the machining of in situ Al4C3–Al composite

Published:2003-05 Issue:3 Volume:24 Page:215-221
ISSN:0261-3069
Container-title:Materials & Design
language:en
Short-container-title:Materials & Design

Author:

Ozcatalbas Yusuf

Publisher

Elsevier BV

Subject

Applied Mathematics,General Mathematics

Reference14 articles.

1. Manufacture of 2014 aluminium reinforced with SiC particle by vacuum hot pressing;Tweed;Mater. Sci. Eng. A,1991

2. Lawley A, Koczak MG, Orban R. Fabrication of nanocrystalline NiAl compacts via combined mechanical alloying and self propagating synthesis. European Conference on Advanced PM Materials, EPMA, Birmingham; 1995. p. 23–5

3. Arik H, Türker M, Sarıtaş S. Investigation of the mechanical properties of in situ Al4C3 reinforced aluminium based composites by mechanical alloying technique. Powder Metallurgy World Congress and Exhibition, Kyoto, Tokyo, 2000, p. 543–9

4. Influence of strain rate on fracture of dispersion strengthened Al–Al4C3 systems;Besterci;Scripta Materialia,1997

5. The machinability of light alloy MMCs;Chambers;Composites Part A,1996

Cited by 71 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Effect of TiB₂ and GNP reinforcements on machinability in drilling of Al7075/TiB₂/GNP hybrid composites produced by powder metallurgy;Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science;2023-11-16

2. Analysis of chip formation mechanism in turning of AA 7075/SiCp MMCs;Aircraft Engineering and Aerospace Technology;2023-09-22

3. Machining Characteristics of Stir-Cast Al-TiB2 Composites in Dry Turning;International Journal of Metalcasting;2023-06-19

4. Research on liquid nitrogen cryogenic milling of 11Cr-3Co-3W martensitic heat-resistant steel;Industrial Lubrication and Tribology;2023-05-02

5. A critical review on tool wear mechanism and surface integrity aspects of SiCp/Al MMCs during turning: prospects and challenges;The International Journal of Advanced Manufacturing Technology;2023-03-29