Abstract
Abstract
The aim of this paper is the modeling and the corresponding experimental validation of angular deep drawing parameters on the tensile strength, wall thickness and height of the square profile cups. The full factorial experimental method was used to collect the data. FE analysis results were compared with experimental measurements. As a consequence, it was observed that angular deep drawing dies gave better results with different angle values than conventional dies with higher drawing ratios. In general, the product quality increased by an increase of the die/blank holder angle. FEM model results were in good agreement with experimental measurements.
Subject
Mechanical Engineering,Mechanics of Materials,General Materials Science
Cited by
5 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献