Incidence of corrosion in low voltage electrical conductor

Abstract

Abstract This research used a salt spray booth to generate accelerated corrosion in a copper conductor, AWG 12-gauge purity of 95.95%, this caliber used in residential electrical installations according RETIE Chapter 3 Article 20 and NTC 2050 338. Additionally, to provide an enabling stage of corrosion, type mouse tail splices were made. The amount of corrosion is measured by weight loss, and incidence of corrosion in transport was evaluated from two perspectives: difference active at the beginning and end of the test power, and the change in resistance of the specimen measured at different times of the experiment. The test piece was subjected to a flow of alternating current into a low voltage system, while corrosion occurred. Using two single-phase two-wire electronic meters, the rate of power supply circuit test was recorded, to check for changes in the energy carried from exposure to the corrosive environment wire. The data collected showed that exposure times of the samples in the salt spray chamber involvement was not very noticeable in the copper wire, highlighting small corrosion spots. Similarly, the energy no changes were observed to induce corrosion, however, the resistance of the wire showed a total change of up to 2.4 [milliohms]. The data collected showed that exposure times of the samples in the salt spray chamber involvement was not very noticeable copper wire, highlighting small corrosion spots. Similarly, the energy no changes were observed to induce corrosion, however, the resistance of the wire showed a total change of up to 2.4 [milliohms].