Plasma-assisted combustion with nanosecond discharges. I: Discharge effects characterization in the burnt gases of a lean flame

Abstract

Abstract The prediction of a flame response to plasma assistance requires extensive knowledge of discharge-induced plasma kinetics. Detailed studies of nanosecond discharges are common in N2/O2 and fresh combustible mixtures but are still lacking in burnt gases. To fill this gap, we define a reference test case and investigate the effects of nanosecond repetitively pulsed (NRP) discharges placed in the recirculation zone of a lean (Φ = 0.8) CH4-air bluff-body stabilized flame at atmospheric pressure. In this zone, the plasma discharge is created in a mixture of burnt gases. Quantitative optical emission spectroscopy, coupled with measurements of electrical energy deposition, is performed to provide temporally (2 ns) and spatially (0.5 mm) resolved evolutions of the temperatures and concentrations of N2(B), N2(C), N2 +(B), OH(A), NH(A), and CN(B) in the discharge. At steady state, the 10-ns pulses deposit 1.8 mJ at a repetition frequency of 20 kHz. Spatially resolved temperature profiles are measured during the discharge along the interelectrode gap. The temperature variations are more pronounced near the electrodes than in the middle of the gap. On average, the gas temperature increases by approximately 550 K. The heat release corresponds to about 20% of the total deposited electric energy. The electron number density, measured by Stark broadening of H α , increases up to about 1016cm−3. These characteristics allow to classify the discharge as a non-equilibrium NRP spark, as opposed to the thermal NRP spark where the temperature can reach 40 000 K and the degree of ionization is close to 100%. These measurements will serve (i) as a reference for future studies in the mini-PAC burner at the same conditions, (ii) to test discharge kinetic models, and (iii) to derive a simplified model of plasma-assisted combustion, which will be presented in companion paper.